Silicone-acrylic scratch plaster “Unixil G”
“Unixil G” is a plaster made on the basis of polymer particles and siloxane additives. The applied plaster gives a uniform-grained appearance to the surface. Adheres well to fine and rough construction surfaces.
It is used for decorative protection of facade wall surfaces of any buildings, including multi-storey buildings with protruding roofs.
• It is distinguished by its easy application and by the fact that it is not coarse, due to the precise ratio between fine and coarse sand filling.
• Extended treatment time.
• High water repellency.
• High resistance to atmospheric influences.
• Relatively high vapor permeability.
• Suitable as a finishing plaster in contact with a coating of a thermal insulation system made of mineral wool.
• Long-term resistance to infection with mold or mildew.
Color shades: White (color 1001), base 1000; JUMIX
• 348 shades from – the JUB color catalog for paints and putties (only for plasters and 1.5 and 2.0),
• 200 shades from – JUB’s color catalog for paints and plasters – shades ending in 2, 3, 4, and 5 (plaster 2.5 only).
Technical data: Granulation: 1.0, 1.5, 2.0, and 2.5 mm; Consumption rate: approximately 2.0 – 5.0 kg/m2 (depending on granulation); Density: approximately 1.80 kg/l; μ coefficient (EN 1015-19): <120; Sd value (EN ISO 7783-2): <0.24 m; Drying before reapplying (T: +20 ºC, relative humidity: 65 %): 6 hours; Protection against getting wet from rain: approximately 24 hours; Water absorption (EN 1062-3): 0.30 N/mm2;
Surface: The surface should be slightly rough, hard, dry and clean, free of poorly-adhered particles, dust, grease, and other dirt. Suitable surfaces: fine mineral plasters of all kinds, basic thermal insulation plasters (cement-based), concrete surfaces, fibre-cement, plasterboard, chipboard and MDF boards and the like. Unsuitable: surfaces painted with facade paints, limestone-based paints, oil paints, varnishes and enamels. For primer, use UNIGRUND or ACRYLCOLOR diluted with water.
Preparation and application: Mix with an electric mixer. Uniform the mixture before use. Dilute with water (max. 100 ml/bucket). Apply by hand with a steel trowel. Smooth the surface with circular sanding using a large plastic smoothing trowel to achieve the smoothest appearance possible. Cleaning of work tools: wash tools with water immediately after use.
Consumption per m²: 2.0kg, 2.5kg, 3.1kg, 5.0kg
Packaging: 25 kg plastic box
Storage: 12 months in original sealed undamaged packaging in dry and ventilated rooms at temperatures from +5 °C to +25 °C. It should not freeze. Keep out of direct sunlight.
*The product is available only at the “DI TRADE GROUP” warehouse in Sofia